HOW TO USE THE COUNTDOWN TIMER
1. Repeat Pressing the MODE button to display
TR (COUNTDOWN TIMER)
operating
mode.
2. Press & Hold the LAP/RESET Button until the Seconds digits BLINK. Press the
START/STOP button to set to the seconds wanted. You can select from 0 to 59
seconds. If you do not wish to set the seconds, go to #3 below.
3. Press the MODE Button to go to the hours. The hour digits will BLINK. Press the
START/STOP button to set the number of hours wanted. You can select from
0
to
23
hours.
4. Press the MODE Button to go to the minutes. The minute digits will BLINK. Press the
START/STOP button to set the number of minutes wanted. You can select from
0
to
59
minutes.
5. Press LAP/RESET button when you have finished. The display will stop blinking.
To reset the Countdown Timer for a different time see "How to Use the Countdown
Timer" and follow instructions.
TO START THE COUNTDOWN TIMER,
Press the START/STOP button (after the countdown timer is set).
The timer will start to countdown.
To interrupt, press the START/STOP button. Pressing the START/STOP button again will
start the countdown from where it last left off.
Note: When Countdown Timer is set for more than ten minutes, a short single reminder
will advise you of 10 minutes remaining and then at 5 minutes remaining.
AUTO RELOAD COUNTDOWN TIMER
will automatically reload for the time preset,
when the timer reaches “
0
”
If you do not wish to start the countdown again immediately, press the START/ STOP
button twice, if alarm is activated. Press once to stop the countdown if alarm is not
activated.
To restart the preset countdown at any time, press the START/STOP button while in the
COUNTDOWN -
TR
mode.
TO USE THE REPEATABLE COUNTDOWN TIMER WITH PAUSES IN BETWEEN
When the auto-repeat countdown timer reaches zero it automatically alarms and starts to
countdown again for the preset time. You can cancel the countdown before it reaches
zero and return to the original countdown time as needed.
You must be in the Countdown Timer Mode to reset to the original countdown time.
PUSH the LAP/RESET button and HOLD IT for approximately 2 to 3 seconds. Digits will
flash showing the amount of time that the countdown was set for originally.