CODING INSTRUCTIONS FOR GLIDEROL TM305c REMOTE
0417223200
GTS 2000 & OPTIMA
1. Carefully remove the light cover by pulling down on tab near front of unit
2. Press the LEARN button once
• A red light will illuminate
3. Press the large button on the handset once and hold until red-light on receiver board turns off - This confirms that
the handset is programmed
GRD+
The following instructions demonstrate how to program a new or additional Gliderol handset to suit your existing
Glidermatic GRD+ garage door operator. Please note, if you are replacing a lost or stolen handset we recommend
erasing all existing handset data from your operator prior to programming your new handset. Please refer to your
Glidermatic GTS+ Owners Manual for further information on this process.
DELETE CODES
To reset the receiver press and hold the learn button (2.) for 12 seconds. This will erase all handsets from the
memory. This is recommended if a remote has been lost or stolen. Any other handsets previously used will need to
be reprogrammed by following the steps above.
Notes - Always use the large button for coding, even if the opener is GRD GTS
GTS 2000
GLIDEROL TM305C & TM390+ are not compatible, but do use the same method of coding...
Step 1 Press and hold the ‘Enter’ button (shown above) for 2 seconds to access the operator menu. The unit will
beep twice to confirm this has been selected. Note: Pressing the enter button for 5 seconds or more will erase all
handset data from your operator - be careful not to press the enter key for longer than necessary. Step 2 Use the
arrow (Up & Down) buttons to select the ‘Learn’ option and press ‘Enter’ to confi
rm selection. The unit will beep
three times to confirm the unit is in Learn mode Step 3 Press the Main/Key 1 button on the handset. The unit will
beep twice to confirm successful coding. Wait approx 3 seconds for the unit to exit setup mode. Your handset
programming is now complete!
