GLG LIGHTING EQUIPMENT
www.goedlichtengeluid.nl
2
1.
GENERAL SAFETY INSTRUCTIONS
This device has left the GLG factory in perfect condition. In order to maintain this condition and to ensure a safe
operation, it is absolutely necessary for the user to follow the safety instructions and warning notes written in
this user manual.
If
the device has been exposed to temperature changes due to environmental changes do not switch it on
immediately. The arising condensation could damage the device.
Leave the device switched off
until it has reached room temperature.
This device falls under protection-class
1
. Therefore it is essential that the device be earthed. The electric
connection must carry out by qualified person.
The device shall only be used with rate voltage and frequency.
Make sure that the available voltage is not higher than stated at the end of this manual Make sure the power
cord is never crimped or damaged by sharp edges. If
this would be the case, replacement of the cable must be
done by an authorized dealer.
Always disconnect from the mains, when the device is not in use or before cleaning it.
O
nly handle the power
cord by
the plug. Never pull out
the plug by tugging the power cord.
During initial start-up some smoke or smell mayarise. This is a normal process and does not necessarily mean
that the device is defective, it should decrease gradually.
Please don't project
the beam onto combustible substances. Fixtures cannot be installed on combustible
substances, keep more
than 50cm distance with wall for smooth airflow, so there should be no shelter
for
fans
and ventilation for heat radiation.
If
the externa
l
flexible cable or cord of this luminaire is damaged, it shall be exclusively replaced by
the
manufacturer or his service agent or a similar qualified person in order to avoid a hazard.
2.
UNPACKING
Thank you for choosing our MINISPOT ML150. For your own safety, please read this manual before
installing the device. This manual covers the important information on installation and applications.
Please install and operate the fixture with following instructions. Meanwhile, please keep this manual
well for future needs.
The MINISPOT ML150 is made of a new type of high temperature strength of engineering plastics and cast
aluminum casing with nice outlook. The fixture is designed and manufactured strictly following CE standards,
complying with international standard DMX512 protocol. It's available independently controlled and linkable
with each other for operation. And it is applicable for large-scale live performances, theater, studio, nightclubs
and discos.
The MINISPOT ML150 adopts a 150W white LEDlamp which features high brightness and stability. Please
carefully unpack it when you receive the fixture and check whether it is damaged during the
transportation. And please check whether the following items are included inside the box:
①
④
①
MovingHead
1PC
②
SignalCable
1PC
③
PowerCable
1PC
④
O
megaClamp
1PC
⑤
SafetyCable
1PC
⑥
UserManual
1PC
