File 71-10 Page 6
SOFTWARE CONFIGURATIONS
Several functions in this equipment can be set to meet your exact needs. These setups are
held in non volatile RAM and will be remembered until changed. These functions are all set
by turning the box off by the 'EXT-OFF-BATT switch on the rear panel and then turning it
back on while holding a particular combination of buttons. To confirm that you are in the
programming mode the "POWER" LED lights immediately. (It usually takes several
seconds)
1) TO RESTORE THE FACTORY DEFAULT SETTINGS :-
Switch on while holding "HANG-UP" & "0".
"POWER" LED lights immediately to confirm set-up operation.
Release "HANG-UP" & "0".
The "POWER" led turns off and then on.
Default settings are now installed and normal operation continues.
2) SET THE POWER ON MIX :-
Factory default has all channels off.
It is possible to arrange which channels are switched on when the equipment is powered
up.
Switch on while holding "HANG-UP" & "1".
"POWER" LED lights immediately to confirm set-up operation.
Release "HANG-UP" & "1".
Select the required mix using the channel on/off switches.
Turn the box off.
3) CHANNELS TO BE FORCED ON WHEN A CONNECTION IS MADE :-
Factory Default has Mic A & Mic B forced on.
When a connection is made, regardless of if the box is manually answered, auto
answered or originates a successful call, it is possible to ensure that any channels can be
forced on despite their current state.
Switch on while holding "HANG-UP" & "2".
"POWER" LED lights immediately to confirm set-up operation.
Release "HANG-UP" & "2".
Select the channels to be forced on. Their LEDs will be on.
Turn the box off.