File 71-10 Page 10
HARDWARE CONFIGURATIONS
HEADPHONES
This equipment is usually supplied with 'split ear' headphone connections. That is cue
programme is wired to only the left ear and mixer output is wired only to the right ear. This
will produce sensible results with either mono or stereo headphones.
Provision has been made however to mix either or both sources into either or both ears. This
is most clearly understood by reference to our drawing number A2-12582. There are 8
possible links that can be made or broken on the PCB GSH84. These links must be made with
a soldering iron as follows:-
To access the board remove the 4 screws holding the front panel.
Open the box. GSH84 is the large PCB attached to the front control panel.
Study Drawing number A3-12584 which shows the position of the links.
Bridge the required links with solder.
Re fit the front panel.
HEADSET CONNECTORS
As standard these units are fitted with Neutric jacks for the headphones. These jacks accept A
or B gauge plugs. (The A gauge plugs are captive). Some customers may prefer headsets
instead of headphones. Because the panel cut outs are standardized, it is practical to fit
Neutric multipin XLRs in place of the headphone jacks.
