Each segment switches the heater
ON for part of an hour. All other
segments will be OFF. For example,
Fig 10 shows the timer set to switch
the heater ON between 8 a.m. and
11 a.m. and between 5 p.m. and 8
p.m. (17:00 to 20:00 hrs, 24-hr clock).
You can select as many ON periods
as you like, within the 24-hour day.
The settings will repeat every day
until changed.
To change ON and OFF times, simply
push in any ‘ON’ segments you wish
to cancel and pull out new segments
as required.
Rotate the timer dial clockwise
(indicated by the arrow) until the
correct time of day is opposite the
reference mark
(see Fig. 10).
Timer Model (2572 model only)
REMEMBER TO OBSERVE ALL SAFETY WARNINGS AT ALL TIMES
Manual Operation –
Slide the control switch to :
O
- (see
Fig. 6).
O
- The heater is OFF, but the timer clock
continues to keep time whilst the heater is
connected to the mains supply and the power
is On.
- This position switches the heater ON
continuously and overrides any auto timer
settings (see Fig. 7).
The heat output will be maximum and
thermostatically controlled - see ‘Thermostat’.
Fig. 7
Fig. 8
Switching to auto –
Check that the clock shows the correct time
of day, then slide the timer control switch to :
- The heater will switch ON and OFF
according to the timer settings (see Fig. 8).
Setting the auto ON and OFF times -
Using your thumb nail or the tip of a pencil,
pull OUT as many segments as necessary
around the dial, according to the times you
require heat (see Fig. 9).
Fig. 9
Fig. 6
Auto operation
DO NOT disconnect this heater from the mains supply unless it is
being taken out of use (e.g. in Summer or for storage), otherwise
the timer clock will stop.
Fig. 10
ON Times :
8-11 a.m and
5-8 p.m
.
