GLD Products
Neptune Dartboard
Item 42-1023
8
1-800-225-7593
www.gldproducts.com
HANDLE INSTALLATION
This dartboard comes with handles for the doors. Use the pre-drilled holes to attach the
handles. You may need to use a pointed object like a pen to push through the holes from the
front of the door to open the hole all the way. Use the supplied screws to secure the handles
to the front of the doors.
POWER INSTALLATION
The AC adapter is located on the rear side of the dartboard at the upper right hand corner.
The dartboard is designed to be powered by an AC to 5V DC, 1000 milliamp (minimum)
adapter, with the DC plug polarity configured as positive (+) outside, and negative (-) inside.
To connect the adapter, plug the DC plug into the DC power jack on the lower left side of the
dartboard and the AC plug into an electrical outlet.
1. The board is not intended for children under the age of 9 years old.
2. The board must only be used with the recommended transformer.
3. The transformer is not a toy.
4. Disconnect the dartboard from the transformer before cleaning.
PROTECTIVE FILM
This electronic dartboard has a clear protective film over the entire display and button area
to prevent scratching during shipping. It is recommended that you remove this film for easier
reading of the display. To remove, simply lift edge, peel off and discard.
WARNING:
Not for use by children without adult supervision.
Darts are not toys and may cause injury if used
improperly. Everyone must stand behind the dart
thrower.