Page 5
GS-CHR-T5
1 and 2-way LED Remote Starter
Programming
Programming Remote Transmitter(s)
1
2
3
4
The System can learn up to a maximum of 4 transmitters. A single
transmitter can be stored in more than 1 memory slot. When a 5th
transmitter is learned the 1st remote is erased.
I G N
Step
1
Step
2
Turn Ignition On.
O F F
Place unit into
Valet Mode
before programming transmitters
See bottom of page for instructions.
Press and hold valet
switch until antenna
LED flashes rapidly.
Step
3
1
x
Press and release the
valet switch once.
Step
4
Press and release
the brake pedal
once.
Step
5
Press the LOCK
button on each
transmitter that you
want programmed.
Step
6
Press and release
the brake pedal once.
Turn Ignition off.
A.
B.
Programming
Ready Mode - For Manual Transmission
1
2
3
4
5
6
&
1
2
3
4
5
6
O F F
Ensure all doors are
closed and the vehicle is
in neutral.
While the engine is
running, engage the
Parking Brake.
Release the Brake Pedal
Press the START button. The
parking lights will flash once
and then stay on.
Turn the ignition off and
remove the key.
Exit the vehicle and
close all the doors. The
engine will shut off once
all the doors are closed.
Programming
To Disable Ready Mode
STANDARD
•
Open any door(s)
•
Open the hood
•
Disengage the parking brake
With Neutral Safety Switch
•
Transmission not in neutral position
•
Open the hood
•
Disengage the parking brake
Note:
If the parking lights
flash 3 times when remote
starting, Ready Mode is not
enabled.
Programming
Enter/Exit Valet Mode
I G N
Turn Ignition On.
A.
B.
C.
Insert the
key and
turn it to
the ignition
(Run/On)
position.
Within 10
seconds
press and
release the
Valet switch 3
times.
The LED
will turn ON
solid blue
and remain
ON.
Programming
Cold Start Mode
To Enable
Press UNLOCK
and START buttons
simultaneously for 1
second until the park
lights flash once.
To Disable
- Press UNLOCK and START simultaneously
- Put the Remote Starter into Valet Mode
- Remote Start the vehicle
- Open the hood
- Press the brake pedal
- Turn the key to the ignition position
- Disable Ready Mode (manual transmission)
Programming
Remote Start / Alarm Diagnostics
Remote Starter Diagnostics
Parking Light Flashes - Before Starting
3x - Ready Mode is disabled
4x - Valet Mode Activated (The LED on the
antenna is on)
5x - Hood open
Parking Light Flashes - After Starting
1x - Normal Stop (Park brake, Brake)
3x - Runtime expired or shut down by remote
4x - No tachometer signal
5x - Hood open
6x - Over crank threshold (8 seconds)
Alarm Diagnostics
Parking Light Flashes - After Disarm
3x - Door open
4x - Shock sensor
5x - Hood open
6x - Trunk open
7x - Auxilliary IN
8x - Tilt Sensor
9x - Ignition
D.
O F F
Turn Ignition off.
3x
1
2
3
4
5
6
&
