3
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-855-HD-GLACIER for further assistance.
P/N 1000004783
____A
____A
□
Preassemble the clips and screws (AA).
□
Place a clip (AA) in the center along each side and along the
edges and space them approximately 3 in. from each end, and
equally along the front, back, and sides. For countertops
thicker than 3/4 in. space the clips up to 1-1/2 in. apart. Turn
clips parallel to U-Channel.
□
Apply silicone sealant (not included) around the cutout on the
countertop surface.
□
Carefully lower the sink (A) into the cutout in the countertop.
□
Lightly tighten clamps (AA) evenly with a screwdriver until the
sink is perfectly tight to the countertop. Do not over tighten.
□
From the top
–
check the seal between the sink (A) edge and
countertop. Adjust clamps (AA) if necessary.
□
Wipe away any excess sealant with a rag.
Installation
1
Preparing the countertop
2
Cutting the counter
□
Position the sink (A) upside down on the countertop.
□
Trace completely around the edge of the sink (A).
□
Draw a line 5/16 in. inside of the outline of the sink.
WARNING:
Always wear safety goggles and gloves when
using power tools to prevent personal injury
□
Drill a pilot hole in all four corners of the inside line.
□
Use a saber saw or jig saw to cut on the inside line.
□
Place a support underneath the cutout portion of the
countertop to prevent it from falling during cutting.
3
Installing the sink
