9
HOMEDEPOT.COM/GLACIERBAY
Please contact 1-800-247-1087 for further assistance.
Faucet Timer and Battery
FAUCET TIMER
FAUCET TIMER
FAUCET TIMER
FAUCET TIMER
Inside the faucet base is a battery-operated 6 month timer.
An amber LED indicator is also located in the front of the faucet base. This LED flashes continuously after 6 months
have passed. This indicates that it is time to replace the battery and filters.
CHANGING THE FAUCET
CHANGING THE FAUCET
CHANGING THE FAUCET
CHANGING THE FAUCET BATTERY
BATTERY
BATTERY
BATTERY
To change the battery, complete the following steps:
1.
Loosen the screw on the right side of the faucet base.
2.
Press the battery housing upwards from the faucet base until it releases from the base.
3.
Replace the battery (CR 2032 or equivalent). Place battery into the holder with the positive (+) side
facing the back of the holder.
4.
When the battery is first replaced, the light in the base will flash six times and turn off. This indicates
the battery is fully charged. After the six flashes, the timer enters the 6 month time cycle. If it
repeatedly flashes two times, the battery is weak and needs to be replaced.
5.
Re-install the battery housing and firmly tighten the mounting screw.
Troubleshooting
Problem
Problem
Problem
Problem
Probable
Probable
Probable
Probable Cause
Cause
Cause
Cause
Solution
Solution
Solution
Solution
The water tastes bad and has an
odor.
The filters are expended.
Replace the filter cartridges.
The system is contaminated.
Sanitize the system. Call 1-800-247-
1087 for instructions.
Faucet LED indicator light does not
function after a battery change.
The battery is dead.
Replace the battery.
The battery is not installed correctly.
Install the battery correctly, paying
attention to the polarity.
Water leaks at the push connect
fittings.
The tubing is not pushed in all the
way.
Push the tubing in all the way into
fittings.
The tubing is not cut square.
Cut the tubing square.
The tubing is nicked.
Remove the nicked portion and
reinsert the tubing into the fitting.
The outer tubing surface is not
smooth.
Remove the rough portion, and
reinsert the tubing into the fitting.
Battery housing
Screw
Battery
negative (-) side
facing the front