4
Installation
1
Installing the spout assembly
CAUTION:
Always turn off the water supply before
removing an existing faucet or replacing any part of a
faucet. Open the faucet handle to relieve water pressure
and ensure that the water is completely shut off.
□
Shut off the water supply.
□
Place the spout assembly (A) through the middle
mounting hole in the sink.
□
Secure the spout assembly (A) with the washer
(G) and the nut (H).
Use the basin wrench to
tighten the nut (H).
2
Connecting the hot and cold
valves
□
Slide the hot and cold end valves (B & C) through
the sink mounting holes. Make sure the long
tubes are installed away from the spout
assembly (A).
□
Secure the end valves (B & C) with the washers
(D) and the nuts (E). Hand tighten the nuts (E)
onto the end valve (B & C) shanks. Lock the nuts
(E) into position by tightening the screws (F) with
a phillips screwdriver.
□
If the handle seat is not aligned with handle in
a line as shown in the above diagram (1), rotate
the handle seat back (the ratating angle can not
exceed 90°) to make the handle seat align with
handle in a line.
NOTE:
The hot side end valve is labeled.
A
G
H
F
E
D
B
A
1
