6
Installation
1
PREPARATION
□
The sink is intended for installation in 36 inch cabinets
□
Verify that the depth of the apron-front of the sink will fit
the cabinet opening and not overlap the cabinet doors
□
Install the strainer and faucet before installing the sink for
ease of installation (optional)
□
Due to the various cutout sizes possible, a template is not
supplied-- use the actual sink being installed as its own
guide
□
The countertop must be flat and level, and not thicker than
1.5 inches (40 mm) or have a larger overhang than 1.5
inches (40 mm); be sure the countertop is fully supported
by the cabinet
□
The sink will not install on countertops with integral drip
edges
2
INSTALLATION
□
Unpack the sink and inspect for defects; if you have any
questions, call Glacier Bay before beginning the installation
□
The countertop must be flat, without drip edges; the
countertop must have less than 1.5 inches (40 mm)
overhang and a maximum thickness of 1.5 inches (40 mm)
□
Measure the countertop, front-to-back, to make sure the
sink will not hit the backsplash
□
If replacing a sink, measure the old sink and make sure the
new sink will cover the cut out
□
Turn off the water supply to the kitchen faucet at the angle
stops
□
Remove the faucet and old sink
□
Check that the water supply and the drain lines are in good
shape and quality for the new sink and faucet installation;
replace if needed
