IV. Maintenance and Common Faults
1. Maintenance:
Shut down the power supply before maintenance and repair!
Maintenance and repair must be performed by the qualified professionals.
Please carefully read this manual before maintenance and repair.
The manufacturer is exempted from liabilities for consequences related to
water sanitation and violations of the operating instructions.
Regularly clean the dust on the surface of the machine.
Clean the filter (only for the air-cooled model) on a regular basis
(recommendation: once a month).
Clean the condenser fins on a regular basis (at least once every six months) by
gently brushing up and down with a soft brush. Do not brush the fins right
and left in order to avoid damage to the fins and influence on cooling effects!
2. Common faults and troubleshooting:
Fault
Possible Cause
Inspection and Troubleshooting
Failure in startup of
the ice machine
1. No
power
supply
is
available.
2. The bin is full of ice.
1. Check the power switch
and cable.
2. Remove ice.
Glace Bay Ice Machine Installation, Maintenance and Operation Manual
Page 9
Automatic shutdown
about 3 min after
each startup
1. The ambient temperature is
too high.
2. The condenser is too dirty.
3. The high-voltage switch is
damaged.
4. The fan is damaged.
5. There is no cooling water in
the
water-cooled
machine.
1. Reduce
the
ambient
temperature, and keep the
specified spacing around
the machine.
2. Clean
the
filter
and
condenser.
3. Replace the high-voltage
switch.
4. Replace the fan.
5. Supply cooling water.
Water shortage
1. There is no water in the
external water source.
2. The water level sensor does
not send the signal.
3. The water level sensor is
damaged.
1. Ensure that there is water
in the external water
source, and open the
corresponding valve.
2. Check the connection and
contact of the water level
sensor.
3. Replace the water level
sensor.
