RFX-3 RECEIVER INSTALLATION
The receiver has five cable inlets which have individual
moisture and insect blanking plates. There are three double
and two single entry clamps for 6/8 core 5mm OD signal
cables. (See fig 2)
Feed the cable from behind the unit and push into the
cable guides. Ensure that the moisture and insect blanking
plates are inserted in to any unused cable clamps.
BATTERY INSTALLATION
1.
Remove the Opal RFX cover
2.
Remove the module from the bracket
3.
Remove the Fresnel lens
4.
Insert 2 x AAA Alkaline batteries into the module as
shown.(fig 3) Put the base of the battery in first then
click the ‘+” in firmly.
To replace the batteries - push out from the holes on the
reverse of the module.
1. Apply the 12VDC to the receiver.
2. Plug in the link wire from the first detector in to the
receiver (see fig 4).
3.Press the respective ‘Channel button’ on the receiver
once - the LED lights
4. Within 4 seconds press the ‘Program button’ on the
detector once.
5. The ‘Channel” indicator blinks twice. The code for that
detector is stored and registered to that channel.
6. Remove the link wire from the receiver and plug into the
aerial transmitter in the back of the detector (see fig 5).
Detection signals will be immediately transmitted to the
receiver.
Repeat steps 2 to 6 for each detector.
To check whether a code is sorted - press the channel
button once - three beeps sound.
To erase a code from the receiver - press and hold down
the channel button until the continuous beeps end - then
release.
1.5 VOL
T
1.5 VOL
T
PROGRAM
BUTTON
FIG 3
SETUP
To transfer the detector code to the receiver.
