PACKAGE CONTENTS
•
1 x D-TECT X Repeater & 1A PSU in IP65 Housing
•
1 x Installation Manual
INTRODUCTION
The D-TECT X Repeater can be used to extend the range
of a D-TECT X detector, or to boost signal in a poor recep-
tion area.
D-TECT X REPEATER
The D-TECT X Repeater must be placed within 500 metres
line of sight between the D-Tect X detector(s) and D-TECT
X Receiver(s). The unit will repeat all signals from D-TECT
X detectors within range and as such does not require any
programming to function.
SPECIFICATIONS
Range
500m (line of sight)
Tamper Switches
Front and rear tamper switches:
case open and removal from wall
Wireless Frequency
868 MHz <25 mW
Current
23mA (12V nominal)
Operating Temperature
-10 to +50 Centigrade, Conformal
coated electronics for increased
stability
Housing
High impact, flame retardant, UV
stabilised Polycarbonate
Protection Rating
IP65
Dimensions
W210mm x H180m x D79m
Weight
750grams NET, 880grams
GROSS
Certifications
POWER SUPPLY MODULE
The GJD Power Supply Module provides a 12 VDC output
from a 230 VAC input that enables the D-Tect X Repeater
to be conveniently installed with easy access to a mains
supply.
INSTALLATION
•
The Power Supply Module requires a 230 VACsupply
on the LIVE input and a neutral on the N connection.
•
An EARTH connection is also provided for the termi-
nation of the earth conductor. Ensure this connection
is securely made.
•
Connect the positive and negative terminals of the 12
VDC output to the corresponding inputs of the D-Tect
X Repeater.
IMPORTANT SAFETY REQUIREMENTS
•
The Power Supply Module MUST be installed and
maintained by suitably qualified engineers and the
installation MUST comply with all relevant code of
practice and regulations.
•
All mains supplies to the module MUST be via a
Residual Current Device (RCD) and an overload
protection device.
•
All mains supplies to the module MUST be
disconnected before removing the cover.
SPECIFICATIONS
Mains Supply Input
230 VAC, 50 Hz
12 VDC Output
12 VDC, 1A
5 VDC Output
5 VDC, 0.1A
Operating Temperature
-10 - +50 degrees centigrade
D-TECT X Repeater
GJD397 Repeater
SIMPLIFIED EU DECLARATION OF CONFORMITY
Hereby, GJD Manufacturing Ltd declares that the radio
equipment type GJD397 D-Tect X Repeater is in
compliance with Directive 2014/53/EU.
The full text of the EU declaration of conformity is available
at the following internet address: gjd.co.uk
