3
Read the instructions and keep them safe. Pass them on if you pass the mixer on.
Remove all packaging, but keep it till you know the mixer works.
important safeguards
Follow basic safety precautions, including:
1 This appliance must only be used by a responsible adult. Use and store it out of
reach of children.
2 Don’t put the appliance in liquid. Don’t use it in a bathroom, near a source
of water, or outdoors.
3 Keep fingers, hair, clothing and kitchen utensils clear of the attachments.
4 Switch off and unplug before fitting or removing the attachments, before cleaning,
and when not in use.
5 Don’t use attachments or accessories unless we supply them.
6 Don’t run the motor continuously for more than 3 minutes, to avoid overheating.
After 3 minutes, let it cool for 5 minutes before reusing.
7 Keep the appliance and the cable away from hotplates, hobs or burners.
8 Don’t try to sit the mixer on it’s end – it’ll fall over.
9 Don’t use the mixer for any purpose other than those described in these instructions.
10 Don’t use the mixer if it’s damaged or malfunctions.
11 If the cable is damaged, return the mixer, to avoid hazard.
household use only
before using for the first time
1 Lay the mixer on a stable, flat work surface.
2 Put the LV plug into the socket under the handle.
3 Plug the adapter into a power socket (switch the socket on, if it’s switchable), and
leave it to charge for 16 hours.
4 Route the cable so it doesn’t overhang, and can’t be caught or tripped over.
the twist lock
5 To change from right angled drive to straight through (or vice versa)
a) switch off (
0
)
b) press the end of the twist lock furthest from the drive head
c) twist the drive head through 90 degrees
d) release the twist lock
6 The drive head twists in one direction only – if it won’t twist, try the other way.
the switch
7 There are 2 speeds available,
1
(low) and
2
(high).
8 To switch off, move the speed control to
0
, the middle position.
fitting the attachments
9 Switch off (
0
) and unplug the mixer before fitting or removing the attachments.
10 Turn the attachment to align the pips on the shaft with the hole in the drive head,
then push it into the drive head till it clicks into place.
removing the attachments
11 To remove the attachment, switch off (
0
), and shake off any excess mixture.
12 Grip the attachment firmly, and pull it straight out of the drive head.