4
Cylinder Assembly
(18~26)
3mm Hex. Spanner
Reverse Exhaust Plate Set
27
2mm Hex. Spanner
17
31
28
29
(B) Maintenance Steps For Cylinder Assy.
Loosen
Cap Screw (31)
using 3mm Hex. Spanner and remove
Reverse
Exhaust Plate Set
(30)
.
Take off
Gasket (29)
,
Water Inlet Tube (17)
,
Rubber Sleeve
(28)
and
Cylinder Bushing (27)
.
Loosen
Set Screw (42)
using 2mm Hex. Spanner and pull out
Cylinder Assembly (18~26)
.
Caution :
When reassembling
Cylinder (21)
Assembly, firstly put the
Cylinder (21)
in right place and rotate
Spindle Assembly
(3~8)
and check if it spins smoothly. Tighten the
Screws (42)
on Front Plate in clockwise direction by using 2mm Hex.
spanner. Secondly tighten 4
Cap Screw (31)
and check again if
spindle rotates freely. If not, disassemble Cylinder Assembly
and investigate the problem.
