Giropes 261246, User Manual

Page: 13 / 40

13
EN USER’S MANUAL STX
7. CONFIGURATION
•
Switch on the hook and, during initialisation, press and hold down the
D
button on the remote control to display “
CAL SP
”.
•
Press the
D
button on the remote control again and the display will show “
SET
”.
•
Press the
A
button on the remote control to display the current step, ex. “
d 2
→
e=2kg
”.
•
Use the D button on the remote control to change the division value and press the
A
button on the remote control to confirm and access
the next parameter.
•
The display now shows the factory-programmed capacity. Use the
D
button on the remote control to change the value
•
Press the
A
button on the remote control to confirm. The display will show the value of the weighing filter, ex. “
fLT 00
”. Use the
D
but-
ton on the remote control to change the filter value (the higher the value, the more stable the weight reading, but the slower the response)
•
Press the
A
button on the remote control to confirm. The display will show ex. “
rng 1
”. Use the
D
button on the remote control to
change the value of the zero range. (The higher the value, the smaller the deviation from zero and the greater the zero recovery. On the
other hand, high values can interfere with the weighing of light loads)
•
Press the
A
button on the remote control to confirm; the display will show “
AUPf0
”. Use the
D
button to select the desired auto power
off time.
0 = no automatic power off
1 = auto power off in 15 minutes
2 = auto power off in 30 minutes
•
Press the
A
button on the remote control to confirm and return to normal weighing mode.