GMM
-
Series Milling Machine
Welding & Cutting accessories
4.1 Conventional protective measures.
Make sure the power turn off.
Pull out the plugs form the socket.
Can not operate the machine in those cases: Turn on the machine accidentally and unknown
the machine’s performance.
4.2 Dismantle Milling Cutter Head
1)
Keep a certain distance when rotates the
guide board components (guide board +
guide board rack)
2)
Twist the drive shaft by the 44-52mm
wrench.
3)
Then detach the guided shift head by the
hexagonal wrench.
4)
Detach the milling cutter head from the
guided shift and the guided shift head by
the hook-type wrench (include the bolts,
directional bearing, guide bush, spacer
and spacer ring).
5)
Put the cutting head and guided shift head
together.
Notice
Avoid damaging the screw hole, so just tight the screw by the
hand, not too tight!
4.3 Milling Cutter Head Replacement
Keep far away from the machine when rotates the guide board components (2) (guide board
+ guide board rack)
As picture shows, assembly including bolts, directional bearing, guide bush, spacer, spacer
ring and milling cutter head.
Put the lock shaft(3015R / 3018R) or the 44-52 mm wrench on the drive shaft, and then
tighten the cutting head on the drive shaft by the hook-type wrench.
As the picture shows, fix the guided shift head on the drive shaft by the hexagonal wrench.
If the guide shift head position is not yet fully aligned with the bevel cutter, adjust the spacer
numbers or the adjustment guide bush to keep them in the best position.
7
