Page 8 of 14
98GC1063 SINGLE CHANNEL HANDSET
Fig.1
Fig.2
The 9GC1063 is the simplest of devices, IN and OUT buttons clearly marked. If you
should wish to stop the awning at any point press the center of the control pad. See
Fig.1 Above. On the back of the handset you will find the P2 button and the battery
tray.
The programming window for this module is only 10 seconds so please
ensure that the programming instructions are read and understood before
attempting to execute them.
1)
Supply power to the motor control module. (It will beep ONCE )
2)
Press the P2 button on the handset TWICE. (The motor controller will beep with
each press)
3)
Press the IN button on the handset. (The awning should retract)
If the awning extends at this point instead of retracting, press the STOP button
immediately, then remove the power supply to the motor controller for at least 10
seconds.
Next repeat steps 1 and 2 above then press the OUT button on the handset to complete
the programming procedure.
Ensure that the awning responds correctly to the handset by pressing the OUT, STOP
and IN buttons alternately.
