Page 14 of 19
When pairing with the 98GC74 it is advised that the awning to be controlled is manually
extended couple of feet to enable the programmer to see if the awning is responding in
the correct direction when the buttons on the wall switch are pressed.
The programming window for this module is only 6 seconds so please ensure
that the programming instructions are read and understood before
attempting to execute them.
First determine which channel of the handset is to be paired with the motor controller,
then;
1)
Select the desired channel on the handset using the Channel select buttons.
2)
Supply power to the motor control module. (It will beep ONCE )
3)
Press the P2 button on the back of the handset TWICE. (The motor controller
will beep with each press)
4)
Press the IN button on the handset. (The awning should retract)
If the awning extends at this point instead of retracting, press the STOP button
immediately, then remove the power supply to the motor controller for at least 10
seconds.
Next repeat steps 1 and 2 above then press the OUT button on the handset to complete
the programming procedure.
Ensure that the awning responds correctly to the handset by pressing the OUT, STOP
and IN buttons alternately.
