INSTRUCTION FOR USE
WINDING
Crown in two positions:
0.
Manual-winding position (crown not pulled out).
1.
Time setting position (crown fully pulled out).
Manual-winding:
Your watch requires regular winding to work normally.
To wind, turn the crown backward and forward when it is in position 0). When fully wound, your
watch has a power reserve of approximately 64 hours.
Warning: do not force the crown once the resistance increases as this could damage the
movement.
SETTING THE TIME
Warning: before making any manipulation, make sure the striking mechanism is disengaged.
1. Pull your crown out to the time setting position 1).
2. Turn your crown clockwise to position the hour and minute hands at the selected time. At the
time signal, push the crown back to position 0). Your watch will restart immediately.
Warning: after making any setting, always return the crown to its original position, to preserve
the water resistance of your watch and prevent any damage to the mechanism. To do so, press
the crown against the case in position 0).
STRIKING MECHANISM
Move the sliding device c) on the left-hand side of the case up to the banking and then release it.
This will activate the striking mechanism, which will then strike the hours, quarters and minutes.
Warning: never change the time when the striking mechanism is engaged.
