Gira 834 Plus, Installation, Start-Up, Operation

Page: 14 / 28

Installation and start-up
14
06.2017/V 1.2
2.6 Adding new devices to a radio emergency set /
deleting device assignments from a radio emergency set
2.6.1 Expanding an existing radio emergency set with one or several devices
i
Note:
The description applies for devices not yet taught in with a set!
The following description applies for single devices to be integrated into an existing set.
Devices that are part of a set (Order No.: 5914 ..) are factory pre-configured and
interconnected.
To delete the device assignment to a radio emergency set, see 2.6.2.
Important:
Only add several devices one after another.
For each device, implement steps 2 to 3 in succession.
Step Set the device into
programming mode Response (signalling)
of the device during teach-in
1 1. Device = radio call module:
Press and hold the program-
ming button for longer than
3 seconds.
2 2. Device = new device
Press and hold the program-
ming button for longer than
3 seconds.
3 Result:
Radio contact is established,
the status LED on both
devices lights continuously
for 5 seconds.
The taught-in device exits
programming mode.
The radio call module remains
in programming mode.
4 Teaching in a further device
Continue with step 2.
5 Exit programming mode
Press the programming button
once.
Flashing frequency: 1
Flashing frequency: 1 Hz
Continuous light: 5 seconds
The LED goes out
Flashing frequency: 1 Hz
Flashing frequency: 1 Hz
The LED goes out