–
Do not mount the media coupler near the earth or ground.
–
Do not place KNX RF devices in metallic small distribution boards or boxes.
–
If several adjacent media couplers are used, place them so their radio ranges
either do not overlap at all, or so they can receive each other. Check within a
system to see if a media coupler can be configured as a repeater.
Media couplers must be accessible even after mounting.
6.2
Commissioning
Commissioning of media coupler/segment coupler
Device connected, power switched on.
￭
Press the programming button.
The status LED lights up red.
￭
Download the physical address and domain address.
The status LED goes out.
￭
Download the filter table and parameters.
Activating the safe-state mode
￭
Disconnect the device connection terminal.
￭
Hold down the programming button.
￭
Reconnect the device connection terminal.
The device restarts. The status LED briefly lights up red and then yellow.
￭
Release the programming button as soon as the status LED starts flashing red
slowly.
Safe-state mode is active.
Activating RF repeater mode
Safe-state mode is activated.
￭
Press programming button again and hold about 2 seconds until status LED
lights up yellow.
The device is in "Repeater prog. mode".
￭
Release the programming button.
￭
Commission the device with a physical address x.y.z (z≠0).
The device is in RF repeater mode.
Resetting the device to the factory setting
Safe-state mode is activated.
7 / 9
32591122
10867569
14.11.2022
RF/TP media coupler/repeater
