GIRA
Info
LED-Clock/Alarm Clock/Thermometer 230 V~
Instructions for Installation
LED-Clock/Alarm Clock/Thermometer 230 V~ 03/99
Page 2 of 4
Battery Change
The end of the battery charge is shown by a point (see illustration
e
) in the LED display.
1. To change the battery, remove the cover and open the battery drawer (see illustration
d
).
2. Replace the old battery with a new one of the same type (lithium button cell CR1025) while paying
attention to the correct polarity.
The battery is laid in the drawer with the + pole up (see illustration
d
).
3. Close the drawer and place the cover on the support ring again.
4. Do not dispose of batteries in normal household waste. Give the batteries to a suitable collection
point.
LED Display
BAT.
H
M
1
2
3
4
5
6
Illustration
e
1. Button: hours/temperature
correction
↓
2. Button:
brightness display/switch off alarm
signal/display change on/off
3. Button: minutes/temperature
correction
↑
4. Display: alarm time 1 on/off
5. Display: alarm time 2 on/off
6. Display: battery
end
Display Alternation On/Off
You can choose from alternating, time, or temperature display.
Press briefly on the button
1 x to pause the display or to start the alternating display.
Time
Display
Temperature-
Display
00:00
°C
00:00
°C
Alternating
Display
Button
press 1 x briefly
Button
press 1 x briefly
Example: The LED Clock/Alarm Clock/Thermometer constantly alternates between time and
temperature. You want only the time to be displayed. Wait until the time appears in the
LED display and then press 1 x briefly on the button
. The time will now be constantly
displayed.
Press 1 x briefly on the button
and the LED display alternates between temperature
and time again.
Setting the time
1. Wait or change (see: Display Alternation On/Off) to the time display.
2. Press the button H to set the hours and the button M for the minutes. To advance quickly, hold
button H or M down.
