04 | SETUP
OPERATION |
05
Make sure
you remove
the Main
Hub from
your PS3™
Slim before
attaching
additional
modules.
set up
The In2Link is very easy to set up, simply follow the instructions below.
operation
The ‘Main Hub’ offers four USB ports- three neatly concealed behind a dust excluding door and another on the
side. The USB ports can be used for any USB device e.g. USB cables, wireless receivers.
01
03
infra-red receiver
An infra-red receiver is built into
the main hub for use with infra-red
peripherals. This can be used with
your Gioteck MX-1 Micro Media
Remote and similar compatible IR
remote control devices.
dc charge
When using high powered USB
devices (e.g. external hard drives)
or charging multiple devices it may
be necessary to connect an
external power supply (not supplied)
to the back of the In2link. The power
supply should be 1A (max)@5V DC.
retractable USB
The Retractable USB module
attaches to the side of In2link main
hub by USB (see page 4).
The cable will extend to a maximum
of 40 cm (15 inches). To extend the
Mini USB cable from the In2link
pull gently (01). To retract the cable,
gently pull the cable out by an
additional 1 cm (half an inch) and
then release.
main hub
To attach the Main Hub, align the
USB connectors on the main hub of
the In2link with USB ports on the
PS3™ and securely push the In2link
into position (01).
additional modules
To add other In2link modules remove the
Main Hub from the PS3™, line up the 2
modules as shown below and click
together (02). You can now attach the
In2link Modules onto your PS3™ (03).
02
01
02
