gio Vyper 4WD 1100cc 4 seater XY1100UEL, Service Manual

Page: 12 / 261

1. SERVICE INFORMATION
1-10
When using a beam-type wrench, tighten the fastener
until the pointer aligns with 16.5 ft. –lb. In this example,
although the torque wrench is pre set to 16.5 ft. –lb.,
the actual torque is 20 ft. –lb.
Pliers
Pliers come in a wide range of types and sizes.
Pliers are useful for holding, cutting, bending, and
crimping. Do not use them to turn fasteners.
Figure 15
and Figure 16
show several types of useful pliers.
Each design has a specialized function. Slip-joint
pliers are general – purpose pliers used for gripping
and bending. Diagonal cutting pliers are needed to cut
wire and can be used to remove cotter pins. Use
needle nose pliers to hold or bend small objects.
Locking pliers (
Figure 16
), sometimes called Vise-
Grips, are used to hold objects very tightly. They have
many uses ranging from holding two parts together, to
gripping the end of a broken stud. Use caution when
using locking pliers, as the sharp jaws will damage the
objects they hold.
Snap Ring Pliers
Snap ring pliers are specialized pliers with tips that
fit into the ends of snap rings to remove and install them.
Snap ring pliers (
Figure 17
) are available with a fixed action (either internal or external ) or
convertible (one tool works on both internal and external snap rings). They may have fixed tips or
interchangeable ones of various sizes and angles. For general use, select a convertible type pliers
with interchangeable tips (
Figure 17
).
WARNING:
Snap rings can slip and fly off when removing and
installing them. Also, the snap ring pliers tips may break.
Always wear eye protection when using snap ring pliers.
Hammers
Various types of hammers are available to fit a number of applications. Use a ball-peen hammer to
strike another tool, such as a punch or chisel. Use soft-faced hammers when a metal object must be
struck without damaging it. Never use a metal-faced hammer on engine and suspension components
because damage occurs in most cases.
Always wear eye protection when using hammers. Make sure the hammer face is in good
condition and the handle is not cracked. Select the correct hammer for the job and make sure to
strike the object squarely. Do not use the handle or the side of the hammer to strike an object.