Gimenez Ganga Saxun Alugan 45, Installation, Use & Maintenance Manual

Page: 10 / 16

10
3.3 Installation of guides.
In the case of installations of guides superimposed on the façade, the screw must be housed in the internal chamber of the profile, avoid-
ing at all times any debris that could cause friction with the slats.
The separation distance between the slat and the bottom of the chamber is 5 mm to ensure correct operation.
3.4 Manual lifting drives.
The lifting system (tape coiler/hoist/crank handle) is not designed for outdoor use, therefore Saxun will not be liable for damage even
within the warranty period.
3.5 Motorisations.
The electrical connection of the motor must be carried out in all cases and without exception by qualified personnel, verifying that the
installation is earthed, in compliance with local or national electrical safety regulations.
Before proceeding with the installation, the installer must ensure that he has read and understood the motor manufacturer's warnings and
instructions.
Under no circumstances should the installation be progressed in case of evidence of anomalies or deficiencies in any of its components
or installation conditions, in order to avoid situations that could represent safety risks for installers, users or the functionality of the instal-
lation itself.
Verify that the electrical system is compatible with the installation to be carried out and that it is in a safe condition to proceed.
In motorised installations it is important to check that there is a socket outlet with the required voltage at a maximum distance of 1.20
metres from the preset position of the motor.
When carrying out motorised installations operated by remote controls, proceed according to the steps included in the operating manual
and instructions given by the manufacturer. In case of outdoor installation of power plants or motors, remember to insulate them from
possible contact with water.
Use a lockable (key-operated) switch if the rolling shutter is installed in buildings such as schools, colleges, hospitals, etc.
The installer shall ensure that the purchaser has the specific technical manuals for the automation controls installed and shall answer
any questions the purchaser may have regarding their proper operation.
The installer shall pay particular attention to informing the purchaser of the basic safety conditions for operation.
Inside
Exterior
5 mm 5 mm