INSTRUCTIONS
The Alternating Pressure Mattress consists of two parts: the mattress and the pump. The pump utilizes a small compressor to remain
quiet and energy efficient. The control panel is simple and very user friendly. The mattress relieves pressure by sequentially deflating
and inflating alternate air cells on approximately 12 minutes timed intervals. It is widely recognized that constant pressure to a bony
prominence is the leading cause of skin breakdown. The continuous movement supplied by the unit lessens the areas of constant
pressure and enhances circulation.
OPERATION
1. Place the mattress on the bed frame with the hose end at the foot section of the bed frame.
2. Using the integrated hooks, securely hang the pump on the bed end at the foot end or place on a smooth flat surface.
3. Connect the air hoses from the mattress to the pump.
4. Plug the pump into a wall outlet. Be sure the power cord is safely away from possible hazards.
5. Turn on the power switch on the control panel of the pump. The pump will begin to inflate the mattress.
6. After inflation, adjust the mattress using the dial on the pump.
CAUTION
1. Do not smoke on or near the pump.
2. Keep the pump away from heated surfaces.
3. Explosion risk if used in the presence of flammable anesthetics.
4. Replace fuse as marked: T1A 250V. Power Input: ~ 220 V - 50 Hz - 0,1 A
PRODUCT SPECIFICATIONS
Disposal: The product must not be disposed of along with other domestic waste. The users must dispose of this equipment
by bringing it to a specific recycling point for electric and electronic equipment.
GIMA WARRANTY TERMS
The Gima 12-month standard B2B warranty applies.
All serious accidents concerning the medical device supplied by us must be reported to the manufacturer and competent authority of the member state where
your registered office is located.
M28575-M-Rev
.2-07.20
28575
Gima S.p.A.
Via Marconi, 1 - 20060 Gessate (MI) Italy
[email protected] - [email protected]
www.gimaitaly.com
Made in China
WEIGHT CAPACITY
ELECTRICAL
Maximum patient weight
331lbs (150kg)
Operating power:
~ 220 V 50 Hz 0,1 A max.
Fuses::
T1A 250 V
ENVIRONMENTAL CONDITIONS
OPERATING CONDITIONS
STORAGE AND SHIPPING CONDITIONS
Ambient Temperature:
10°C to 40°C
(50°F to 104°F)
Ambient Temperature:
-18°C to +43°C
(0°F to 110°F)
Relative Humidity:
10% to 75%
Relative Humidity:
10% to 95%
Keep in a cool,dry place
Keep away from sunlight
Caution: read instructions (warnings)
carefully
WEEE disposal
Manufacturer
Medical Device compliant
with Regulation (EU) 2017/745
Follow instructions for use
Type BF applied part
Class II applied
Product code
Lot number
Medical Device