°C/°F SWITCHABLE
Temperature readings are available in the Fahrenheit or Celsius scale (°C/°F) located in the upper right corner
of LCD.) With the unit off, press and hold the On/Off Button for approximately 4 seconds to change the current
setting.
DIRECTIONS
1. Press the On/Off Button next to LCD display. A tone will sound as the screen shows followed by
last recorded temperature. After showing the self-test temperature, the thermometer is now in the testing mode.
*Note: If the measured temperature is less than 32°C or 90°F, the LCD will display Lo, if the measured
temperature is higher than 42.9tor 109.9’F, the LCD will display Hi.
2. Position thermometer in desired location (mouth, rectum, or armpit.)
a)
Oral Use:
Place thermometer under tongue as indicated by “ √ ” position shown
in Figure 2. Close your mouth and breathe evenly through the nose to prevent
the measurement from being influenced by inhaled/exhaled air. Normal temperature
between 35.7°C and 37.3°C (96.3°F and 99.1°F).
b)
Rectal Use:
Lubricate silver probe tip with petroleum jelly for easy insertion. Gently
insert sensor approximately lcm (less than 1/2”) into rectum. Normal temperature
between 36.2°C and 37.7°C (97.2°F and 99.9°F).
c)
Armpit Use:
Wipe armpit dry. Place probe in armpit and keep arm pressed firmly at side. From a medical
viewpoint, this method will always provide inaccurate readings, and should not be used if precise
measurements are required. Normal temperature between 35.2°C and 36.7°C (95.4°F and 98.1°F).
3. The degree sign flashes throughout the testing process. When flashing stops an alarm will beep for
approximately 10 seconds. The measured reading will appear on the LCD simultaneously. The minimum
measurement time until the signaling tone (beep) must be maintained without exception. The measurement
continues even after the buzzer notification. The displayed temperature will not change when thermometer
is removed from its testing position.
*Note: Normally the buzzes are “ Bi-Bi-Bi- Bi-” ; Alarm beeps more rapidly when temperature reaches
37.8°C (100°F) or higher ,and the buzzes are “Bi-Bi-Bi ------ Bi-Bi-Bi ------ Bi-Bi-Bi”
4. To prolong battery life, press the On/Off Button to turn unit off after testing is complete. If no action is taken,
the unit will automatically shut off after around10 minutes.
5. Store the thermometer in its protective case.
BATTERY REPLACEMENT
1. Replace battery when “ ” appears in the lower right corner of LCD display.
2. Pull battery cover off as shown in Figure 3.
3. Gently pull out plastic circuit board with battery chamber approximately 1 cm (slightly less than 1/2”.)
(See Figure 4)
4. Use pointed object such as a pen to remove old battery. Discard battery lawfully. Replace with new 1.5V DC
button type LR41 or SR41,UCC392, or equivalent. Be sure battery is installed with “+” polarity facing up.
(See Figure 5)
5. Slide battery chamber back into place and attach cover.
CLEANING AND DISINFECTION
Wipe the thermometer with a soft clean cloth.
For stubborn stains, wipe the thermometer with a cloth that has been dampened with water or a neutral detergent
solution and then wring thoroughly. Finish by wiping with a soft dry cloth.
Observe the following to prevent damage to the thermometer.
- Do not use benzene, thinner, gasoline or other strong solvents to clean the thermometer.
- Do not soak the sensing section in alcohol for long periods of time or attempt to sterilize it using hot water
(water at a temperature of 50°C (122°F) or higher).
- Do not use ultrasonic washing to clean the thermometer.
LIMITED WARRANTY
The thermometer is guaranteed for one year from the date of purchase. If the thermometer does not function
properly due to defective components or poor workmanship, we will repair or replace it free of charge.
All components are covered by this warranty excluding the battery. The warranty does not cover damages to your
thermometer due to improper handling. To obtain warranty service, an original or copy of the sales receipt from
the original retailer is required.
Disposal of this product and used batteries should be carried out in accordance with the national
regulations forthe disposal of electronic products.
Ingress Protection Rating:
IP 27
Classification:
Type BF FAII
M-25564-GB-Rev
.0.09.17
25564 / KD-101
Kellyunion Electronics Co., Ltd
No. 114, Five Star Village, Jiangkou Town
Hanjiang District 3511115 Putian, Fujian
PEOPLE’S REPUBLIC OF CHINA
Made in China
Landlink GmbH
Dorfstrasse 2/4, Emmendingen, 79312 Germany
0123
Figure 2
Figure 3
Figure 4
Figure 5
