5
Vortex Mixer
| USer’S GUiDe
introDUction
|
Vortex Mixer
Installation
1. Place the Vortex Mixer on a clean, flat, stable surface and
press down slightly to allow the suction cup feet to adhere.
2. Make sure that the mode switch is in the oFF position and
plug the vortex mixer into a properly grounded outlet.
3. Using the speed control knob, adjust the mixing speed to
the desired setting.
4. check that the cup head is securely fastened by gently
rotating it clockwise.
5. Start at the middle of the speed range if you are uncertain
of what setting you need.
Operation
in touch mode, the tube to be mixed is pressed downward
against the head to activate the vortex mixing action.
NOTICE
Avoid the use of solvents as they may attack the rubber cup
head or the acrylonitrile butadience styreme (ABS) plastic
housing.
Head Removal and Replacement
to change or replace the rubber head attachment, grasp the
unit body with your left hand, and then gently rotate the head
attachment counter clockwise with your right hand until the
cup head is completely unscrewed.
replace the head attachment by gently rotating clockwise
until it is tight and you feel the rubber start to grip the top of
the dynamic drive assembly.
NOTE
Attaching accessory heads requires the use of a Phillips
screwdriver to tighten the center screw in the accessory
head.
