OSCILLATION OPERATION
To start 360° air flow direction, press the "Fan
Oscillation Button" (Feature No. 18) on the control
panel or (Feature No. 32) on the remote controller once;
LED light(Feature No.10) will become illuminated on the
control panel and the rotary fan grille will begin to rotate,
directing air in a full circle. This setting will be memorized
and keep unit next operation. Press the same button to
turn off the function.
IONIZER OPERATION
Press the "Ionizer Button" (Feature No. 15) on the control
panel to release the anions. Illuminated light is on the
control panel will indicate function is currently in operation.
Press the same button to turn the function off.
TIMER OPERATION
1. Press the "Timer Button" (Feature No. 14) on the
control panel or (Feature No. 29) on the remote
controller to set the countdown timer. The unit will
operate with its present settings until the timer
counts down.
2. Timer can be set from 1 to 8 hours.
3. Once set, LED display will show the time set.
4. To switch off the timer function and operate the
unit continuously, press the timer button until LED
display switches off and the LED light on the control
panel above timer button LED will also be off.
REMOTE CONTROLLER
1. Open the remote control battery flap (Feature No.
33) and insert 1 piece 3V "CR2032" of Button battery.
2. Remote controller must be aimed at the sensor
(Feature No.1) on the front of the appliance, distance
within 5 meters, and will not function from beside
or behind the appliance.
CLEANING AND MAINTENANCE
(SEE DRAWING 4)
1. Ensure the unit is switched off and disconnected
from a power source before cleaning.
2. Clean outer casing or control panel with a damp
cloth only - do not use any abrasive cleaners or
harsh chemicals, and ensure the control panel or
LED is out of reach of water.
3. Check the condition of misting and water tank before
every use.
4. After long time operation with this appliance, the
unit may become clogged with dust and dirt, which
will greatly affect the performance of the unit.
Sometimes mold and mildew may also occur due
to the water tank not regular cleaned, recommend
to clean once every two weeks.
5. Press the “Fan
power ON/OFF”
button.
6. Select the Fan
Speed to start.
7. Press the “Misting
ON/OFF” to start
misting.
8. Adjust the mist density by
turning the “Misting volume
control” knob.
DRAWING 3
Warning :
1. Low Water Level Alarm: when water level becomes
low, you will hear the “beep” sound and the “Mist
Indicator” will flash for a second. At the same time
the power of the pump inside the unit will be cut off
to protect the life
of the pump.
To stop the alarm,
turn off the unit from
the power outlet.
Fill the tank with
water and turn on
the unit again.
4. Connect to the power socket, press fan power ON/OFF
button, select the fan speed to start and press
"Misting ON/OFF Button"(Feature No.16) on the
control panel or (Feature No.31) on the remote
controller to switch the misting on or off; illuminated
lights on the control panel will indicate the functions
currently in operation.
5. Adjust the mist density, turn the "misting volume
control"(Feature No.4) clockwise to increase the
mist density or anti-clockwise to decrease the mist
density, then get an optimum mist performance as
required.
6. It may take a minute for a new misting fan to start
the misting, it is normal for air to come out of the
nozzles before water and the mist.
2. DIRECT POUR WATER INTO MIST FAN IS
PROHIBITED.
(SEE DRAWING 3)
