Ground Sleeve Caps are
available but sold separately.
Ground Sleeve Cap #73119021
A
On the two rear most poles, install
eyebolt (M2745) with nylock nut (1254)
at hole 11ft from the ground. These will
be used to secure the rear door flap.
Install eyebolt (M2745) with nylock nut
(M1254). Hook rubber strap (M733)
between the eyebolt and main net.
Install rope cleats (M2245) with
self drilling screws (HDWE06288).
There are pilot holes.
Before putting the net poles into the ground sleeves, install all of the hardware onto the poles.
Tie one end of a 50ft rope to the bottom rope cleat. Run it through the top pulley and back down.
Tie the free end of the rope onto a snap hook (M2223). This will be used to raise the net.
Install the pipe cap (PCAP00158002).
Install pulley (73210042) with 5/16"-
18 nylock nut (M1254). The open
side of the eye-bolt should be up.
On the two front poles, install a
second pulley (PULY00100) with a
quick link (CHAN00021000).
After the pole is set in the ground sleeve,
install the net flip arm at ground level with u-bolt (M2298),
washers (M2263), and 1/2"-13 nuts (HDWE030030E0).
After the net is installed, clip the bottom of the net to the
end of the flip arm.
www.gillathletics.com
800-637-3090
5/26/2019
INST742125
Page 7 of 19
742125 - NCAA TALL DOUBLE CIRCLE HAMMER/DISCUS CAGE
NET POLE INSTALLATION
Copright C
All rights reserved.
2019 by Gill Athletics.
