Gill Instruments Limited
_____________________________________________________________________________________________________________
________________________________________________________________________________________________
MetStream 105
Page 54
Issue 1
Doc. No. 1955-PS-001
April 2014
Data should now be scrolling on the Hyperterminal screen updated at the connected
instrument output rate (MetPak Pro data illustrated).
Should it be necessary to place the connected instrument into a Set Up
mode/Configuration mode then send the necessary command (for Gill sensors this is the *
command).
To interrogate the connected instrument:-
Type * to place the unit into Set up Mode (Enter key not needed).
The connected MetPak Pro unit has responded with SETUP MODE.
Refer to the connected Sensor Manual to determine which Configuration or Test
commands are applicable for a terminal mode connection.
In this MetPak example the ‘Report’ command has been typed, the Enter key pressed and
the unit has responded with the fields that it is reporting to MetStream.
Type Q and press Enter key to return to normal measurement mode.
