Gilian Gil Air Plus Manual Download Page 2

Page: 2 / 9

IOM Sampling with the Gilian GilAir Plus Pump Procedure

Calibration

Set up:

1. Place IOM face down (filter opening) onto the calibration adapter. Keep the IOM

centered.

2. Screw down onto the IOM until snug, NOT tight!

Screwing the bolt too tight

can cause the IOM to crack.

3. Place tubing on each end of the calibration adapter.

Photo 2. Loading the IOM in the Calibration adapter

4. Connect

tubing with attached media onto the “suction” inlet of the calibrator;

funnel side of adapter goes towards the calibrator.

Calibration

IOM

Calib

ratio

IOM

Cal. Adapter

Summary of Contents for Gil Air Plus

Page 3: ...IOM Sampling with the Gilian GilAir Plus Pump Procedure 3 Photo 3 Tubing Configuration of the Calibrator Calibration adapter and Pump ...

Page 4: ...ower button until the light inside turns on and the piston will drop Photo 4 Calibrator Powered On Piston Dropped 2 The measure option will be highlighted Select Enter 3 Use the right arrow to scroll over to CONT Continuous to run the calibrator continuously until manually stopped 4 Connect other end of tubing onto pump inlet ...

Page 6: ...Once pump is calibrated disconnect it from calibration train 2 Attach tubing with APHC LAB IOM sampler to the pump inlet tubing will be approximately 20 inches in length for personnel sampling 3 Use clip on backside of pump to hook on person s belt behind the hip as indicated in photo 7 Photo 7 Gilian Pump Appropriately Attached to Belt ...

Page 8: ...Pump 8 When done sampling press the check mark power button Use down arrow to scroll to Stop Press check mark power Stopping the run will end that sampling event Pausing the pump will pause the current sampling event and will resume once started again Photo 10 Pausing or Stopping the Gilian Pump ...