Gilera Runner RST Purejet, Service Manual, Page: 100 / 235

- Prepare the fitting surface using the recommen-
ded product applying a thin layer after degreasing
the surface with a suitable solvent (e.g. trichloro-
ethylene)
Recommended products
Loctite 510 Liquid sealant
Gasket
- Assemble the equipment need to close the crank-
case half (screws, wrench).
- Heat the crankcase half on the flywheel side us-
ing the thermal gun, with the same procedure on
the transmission side crankcase half.
- Keep the transmission side crankcase half in hor-
izontal position to introduce the flywheel side
crankcase half with a firm and precise move.
N.B.
WEAR GLOVES WHEN HANDLING THE
CRANKCASE HALF. DO NOT USE RAGS FOR
THIS OPERATION
.
- Insert at least 3 fixing screws and tighten quickly.
- Insert 5 more screws and tighten at the prescribed torque.
Locking torques (N*m)
Crankcase closing screws: 12 -13 Nm
- Move the crankcase separation plate in a position
back from the one indicated in the figure
- Install the special magnetic support with dial
gauge at the end of the crankshaft
- Check the axial clearance of the crankcase
If this is not within the maximum limit allowed, re-
peat the crankcase coupling procedure
Specific tooling
020335Y Magnetic support for dial gauge
Engine
Runner RST Purejet
ENG - 34