Use the drop down to the right of the Input Action to select the desired
scaling value to use. A ‘zero’ value sets all of the outputs to the voltage set
in the ‘minimum’ endpoint column. A value of 100% returns the Br-EFB to
normal operation.
M) Binary Bit
This Input Action allows you to use as many as two of the trigger inputs
to select and play shows using a binary pattern of bits. This allows you to
select and play up to 3 shows through the Optically Isolated Trigger Inputs.
You can define any of the inputs to any of the binary bits zero through
seven. Each of the binary bits should only be used once.
When any of the inputs that are assigned as a binary bit changes, the
entire binary byte is scanned. If the result is non-zero, the binary value is
used to select and play a show. Care must be taken that all the binary bits
are switched simultaneously. Some PLCs have an output update rate
which is slower than the Br-EFB’s input scan rate, which can result in
unexpected shows being selected and played.
Gilderfluke & Co.• 205 South Flower Street • Burbank, California 91502 • 818/840-9484 • 800/776-5972 • fax 818/840-9485
Br-EFB Manual / May 22, 2018 3:28 PM / page 132 of 142
