Page 26
MDE-4780D FlexPay™ EPP and SCR Kit (EPK ECIM RF) Installation Instructions for Encore® S E-CIM™ · December 2015
Installing FlexPay EPP Kit
5
Check if any cables were disconnected from the color screen CRIND CPU assembly when
installing the flash card. Secure/reconnect any loose/disconnected cables.
Figure 30: Reconnecting Cables to Color Screen CRIND CPU Assembly
(i)
(ii)
6
After the flash upgrade has been performed, reload the personality screen(s). For more
information on how to reload and configure the personality screens, refer to
MDE-4769
Personality Screen Change for Color Screen Update and/or Upload Instructions
.
7
Proceed to
.
Completing Installation
To complete the installation, proceed as follows:
1
Restore power to the unit.
2
Purge memory.
3
When the dispenser comes up, enter the CRIND diagnostic mode, program the CRIND IDs,
CRIND mode, and enable any peripheral devices (cash acceptors, TRIND, and so on).
4
Use the FlexPay EPP mapping tool to map keys (and their associated functions) present in the
current keypad to those present on the FlexPay EPP. For more information, refer to
MDE-4784
FlexPay Encrypting PIN Pad Start-up and Service Manual
.
5
Bring the Point of Sale (POS) back on line by reconnecting the CRIND two-wire cable or by
de-isolating at the Distribution Box (D-Box).
6
After the CRIND downloads from the POS, run a keypad test.
