GILBARCO VEEDER-ROOT C00016 Series, Installation Manual

Page: 10 / 34

Installing Mat Reader Assembly
Page 10 MDE-4017G Mat Reader Assembly Kit (C00016-XXX) Installation Manual · April 2017
Mounting and Connecting Mat Reader Interface Box
To mount and connect the mat reader interface box, proceed as follows:
1
Mount the mat reader interface box by following the procedures in “Mounting Mat Reader
Interface Box” on page 33 .
2
Run both power and data cables to the port end of mat reader interface box (see Figure 3 ) as
follows:
a
Connect the J3 end of the Ribbon Cable (M01872A001) to the interface P3 port.
b Connect the P1 end of the work area cable to the J1IN port. The other end will be

connected later.
c If daisy chaining the mat reader interface boxes, connect the work area cable from the
J2OUT port on this interface box to the J1IN port on the other interface box.
Figure 3: Connecting to Mat Reader Interface Box
Connect Power
Supply here
Connect P1
end of work
area cable
If daisy chaining, connect
work area cables from J1IN
on other Interface Box here
Connect J3 end of
Mat Reader Drive
Cable here
3
Position the mat reader face down (see Figure 4 ).
Figure 4: Bottom Side of Mini Mat Reader - Low Frequency
Cable to
Interface Box
Bottom Side of Mini Mat Reader
Three channels from which to
choose one (remove neoprene
material from selected path)
Neoprene Foam Tape
(M024498B001)
Carefully connect
and cover with
Neoprene Foam
Tape