20
Ad
di
ti
on
al
I
nf
o
Specifications
Power Supply ............................................................................................ AC/DC adaptor 5 VDC @ 2 A
Output Power ......................................................................................................................2Wx2 RMS
Impedance ...................................................................................................................................4 ohm
Frequency Response ................................................................................................... 200 Hz – 15 kHz
S/N Ratio .......................................................................................................................... >65 dB @1 W
Cord Length ....................................................................................................................... 6 ft (180 cm)
Connectors ......................................................................................................... 30-Pin iPod connector
..................................................................................................................................
Ç”
(3.5mm) phono
Specifications are subject to change and improvement without notice. Actual product may vary from the
images found in this document.
FCC Information
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can radiate radio frequency
energy and, if not installed and used in accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try to correct the interfer-
ence by one or more of the following measures:
• Reorient or relocate the receiving antenna.
