Intermec CS40 Handheld Information
Intermec CS40 Handheld Information 080511.doc
Page 8
Setup
Wireless Security Choice for 802.11 (WiFi) Radio (
If USING Personal WPA/WPA2
):
1) Tap:
Start
>
Settings
>
System
>
Intermec Settings > Communications >802.11 Radio
>
Funk Security
2) Select
the
Profile 1
. (or 2, 3 or 4 if adding additional Profiles)
3) Enter
Profile Label
(name)
4) Check
radio Box for Network type
:
a. Infrastructure for Access Points (
this is the typical choice
)
b Ad Hoc for PC to PC, or Device to Device, or Device to PC
5) Enter
SSID
(unique wireless network name)
6) Check
radio Box for Power Mode
: check
CAM
(for constant awake mode)
7) Select
802.1x security type (if used
):
none
8) Select
Association
:
WPA or WPA2
9) Set your PSK (aka, Pre-shared key)
The pre-shared key must be a value of 32 hex pairs
preceded by 0x
for a total of 66 characters. The value must match the key value on
the access point. The passphrase must be from 8 to 63 characters.
After you enter a passphrase, the 70 Series internally converts it to
a pre-shared key. This value must match the passphrase on the
authenticator.
10) The rest of the screen requires scrolling through to set any necessary security options.
If you don’t know what these are – contact the IT staff.
11) To Save your settings, Select
OK
at the bottom menu panel if no additional changes are
needed.
Setup
Wireless Security Choice for 802.11 (WiFi) Radio (
USING Any OTHER Security
Option)……
Reference the supplement document located on the GigaTrak website:
Personal WPA/WPA2
): IntermecCK_CN_SC Series WirelessConfigSupplement
Select
Active Profile for Wireless Security for 802.11 WiFi) Radio:
1) Tap:
Start
>
Settings
>
System
>
Intermec Settings > Communications >802.11 Radio
>
Funk Security
2) Select
Active Profile
3) Check
desired
Profile
(1, 2, 3 or 4)
4) Enter
Profile Label
(name)
5) Select
OK
at the bottom menu panel.
