ASSEMBLY INSTRUCTIONS
Frame Parts
x10
Fiberglass Poles
Stakes
Step 1- TENT SET UP
To prolong the life of your tent floor we suggest using a ground cloth cut slightly smaller than the floor of your tent and that you select
a clean level area for your campsite.
1) Spread the tent body out on the ground.
2) Fully open all of the poles.
3) Carefully thread BOTH of the main poles through the pole sleeves. (Figure A)
4) At the end of one of the main poles insert the pin attached to a ring at the corner of the tent floor into the end of the pole. (Figure B)
5) At the opposite end of the pole start to push the pole through the pole sleeve while holding onto the corner of the tent.
Note: be careful not to get the pole caught while pushing as the pole can break.
6) As you continue pushing the pole will start to bend. Continue to push until you can put the pin into the end of the pole.
7) Repeat for the other main pole.
8) Attach the 4 pole clips to the poles. (Figure C)
9) Tie the cords sewn to the top of the tent around the 2 poles. (Figure D)
TENT SET UP DIAGRAM
Tent Poles (x2)
Fly Poles (x1)
PA
T P
EN
DI
NG
145
o
P. H
.E N
G-K
OR
E A
1
2
3
4
5
6
7 8 9
9 9 10 11
12