1.INFORMATION
Model PCR2lO: RFID Code Verifier with 20*2LCD Display
Model PCR212: RFID Code Verifier without LCD display
A. Standard Package
Main
unit
1pc
This device complies with Part 15 of the FCC .
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any
interference received, including interference that
may cause undesired operation.
B. Optional Items
1. Power supply adaptor DC 9V/12OV AC
2. Power supply adaptor DC 9V/230V AC
3. Proximity card
2.INTRODUCTION
PCR2lX RFID Code Verifier is so-called contactless card reader and it is based on RFID technology. So
it can read and verify RFID cards, tags and transponders contactlessly.
PCR2lX is a compact proximity reader with RS-232 interface .The product is totally compatible with the
PC AT/XT series personal computer or any computer with RS-232 interface input.
PCR210 is with 20*2 LCD display and can be used as an standalone unit to read and verify RFID codes
of the transponders without computer or can be used as an on-line unit with computer.
PCR212 has two LED indicators on the reader panel and a buzzer inside which provide the operator with
continuous status of the reader operations.
The major functions of PCR21X reader are:
A. Reads RFID transponders, such as contactless chip cards and tags
B. RS-232 interface, none parity, 8 data bits, l stop bit, baud rate 2400 ~ 19200 selectable
C. STX/ETX selectable
D. CR selectable
E. Output data length selectable
F. Data in Decimal format or in Hexadecimal format selectable
G. Generates audible beep when reading is successful
H. External power supply DC 9V, 300mA
I. Reads RF/ID cards and tags contactlessly
3.INSTALLATION
Reader can be put on the table or can be attached to any flat surface by Velcro fasteners.
A. Set function DIP switches .See
DIP SWITCH SETTING
.
Note: Must turn off the power of the reader when setting DIP switches.
B. Connect the RS-232 cable 9-pin connector to the proper serial COM port of the computer.
C. Plug the power adaptor into the DC jack on the unit.
Note: Make sure the power adaptor is unplugged from the power line outlet before you plug the
adaptor into the DC jack.