48
Customer Service & Assistance
Gigaset S79H / en / A31008-M2151-S301-2-9U19 / appendix.fm / 26.04.2010
V
e
rsion 4.1, 21
.11.2007
Questions and answers
If you have any questions about the use of
your phone, you can contact us 24/7 at
www.gigaset.com/customercare.
The table below contains a list of common
problems and possible solutions.
Authorisation
This device is intended for use within the
European Economic Area and Switzerland. If
used in other countries, it must first be
approved nationally in the country in
question.
Replacement or repair services are not
offered in countries where our product is not
sold by authorised dealers.
We, Gigaset Communications GmbH,
declare that this device meets the essential
requirements and other relevant regulations
laid down in Directive 1999/5/EC.
A copy of the 1999/5/EC Declaration of Con-
formity is available at this Internet address:
www.gigaset.com/docs
Сертификат
N
o
РОСС
DE.
МЛ
05.
В
00992,
срок
действия
с
01.07.09
по
30.06.2012.
Юридический
адрес
изготовителя
:
Gigaset Communications GmbH
Hofmannstrasse 61,
81379, Munich, Germany
The display is blank.
1. The handset is not switched on.
¥
Press and
hold
the end call key
a
.
2. The battery is empty.
Charge the battery or replace it
(
Not all menu items are displayed.
The menu display is Simplified (
standard mode
).
¥
Activate Complete menu display (
expert
mode
•
No Base
flashes on the display.
1. The handset is outside the range of the base.
¥
Move the handset closer to the base.
2. The base's range is reduced because
Eco Mode is activated.
¥
Deactivate Eco Mode (
reduce the distance between the handset
and the base.
3. The base is not switched on.
¥
Check the base power adapter.
Please register handset
flashes on the display.
Handset has not been registered with the base or
has been deregistered.
¥
Register the handset (
Handset does not ring.
1. The ringtone is deactivated.
¥
Activate the ringtone (
2. Call divert set for "All Calls".
¥
Switch off call divert.
3. The phone only rings if the phone number
has been transmitted.
¥
Switch on the ringtone for anonymous
calls (
The other party cannot hear you.
You have pressed the mute button
h
.
The handset is "muted".
¥
Unmute the microphone (
You hear an error tone when keying an input
(a
descending tone sequence).
Action has failed/invalid input.
¥
Repeat the operation.
Watch the display and refer to the user guide
if necessary.
Exclusion of liability
Some displays may contain pixels
(picture elements), which remain acti-
vated or deactivated. As a pixel is made
up of three sub-pixels (red, green, blue), it
is possible that pixel colours may vary.
This is completely normal and does not
indicate an error.