36
Gigaset R650H PRO / HSG GR-IE-UK-International / A31008-M2762-R121-1-7619 / applications.fm / 3/8/16
Te
mplat
e
B
o
rn
eo
, V
e
rs
ion 1
, 21.
06
.2
012
Room monitoring
During the sounding of the alarm
you can turn the volume
(up) or
(down) continuously
using the side keys.
Deactivating the alarm call/repeating after a pause (snooze mode)
Prerequisite
: One alarm call sounds.
¤
Deactivating until the next alarm call:
Press
OFF
.
Or:
¤
Snooze mode:
Press
Snooze
or any key. The wake-up call is deactivated and then repeated after 5 minutes.
Or:
Press nothing. The alarm call is deactivated after 60 seconds and then repeated after
5 minutes. After the fourth repetition, the alarm call is deactivated for 24 hours.
Room monitoring
When the room monitor is switched on, the stored (internal or external) destination number is
called as soon as a defined noise level is exceeded in the vicinity of the handset. The alarm to an
external number is cancelled after approximately 90 seconds.
You can answer the alarm using the
Two Way Talk
function. This function is used to switch the
loudspeaker of the handset located in the room being monitored on or off.
In room monitor mode, incoming calls are only indicated on the display (
without ringtone
). The
display backlight is reduced to 50%. Advisory tones are deactivated. All keys are locked, with the
exception of the display keys and the ability to press the centre of the control key.
If you accept an incoming call, the room monitor mode is suspended for the duration of the call,
but the function
remains
activated. The room monitor mode is not deactivated by switching the
handset off and on again.
The handset should be positioned 1 to 2 metres away from the area of the room being
monitored. The microphone must point towards the area of the room being
monitored.
Activating the function reduces the operating time of your handset. For that reason,
place the handset in the charging cradle if necessary.
The room monitor is activated 20 seconds after switching on.
The answer machine for the destination number must be switched off.
After switching on:
¤
Test sensitivity.
¤
Test the connection, if the alarm is being forwarded to an external number.
