5
User Manual Athens/China C36H handset, English.
Appendix
Entering special characters
Standard characters
Specifications
Recommended battery pack
(Valid at the time of going to press)
Nickel-metal-hydride (NiMH):
C36H handset: V30145-K1310-X359, -X402
The handset is supplied with the recommended
battery pack.
General specifications
Care
Wipe the handset with a
damp
cloth (do not use
solvent) or an antistatic cloth.
Never
use a dry cloth. This can cause static.
Contact with liquid
If the handset has come into contact with liquid:
◆
Switch off the handset and remove the
battery pack immediately.
◆
Allow the liquid to drain from the handset.
◆
Pat all parts dry, then with the battery compart-
ment open and the keypad facing down place
the handset in a dry, warm place
for at least
72 hours
(
not
in a microwave, oven etc.).
◆
Do not switch on the handset again until it is
completely dry.
When it has fully dried out, you will normally be
able to use it again.
Questions and answers
If you have any queries about the use of your
phone, you can contact us any time at
www.gigaset.com/cn. Or
Call hotline: 4006 706 007
The table below contains a list of common
problems and possible solutions.
1x
2x
3x
4x
5x
6x
1
Space
1 £ $ ¥ ¤
Q
.
,
?
!
0
+
P
* /
(
)
<
=
#
Abc-->
123
123-->
abc
#
@
\
&
WDCT standard
is supported
Range
up to 300 m outdoors,
up to 50 m indoors
Power supply to
charging cradle
230 V ~/50 Hz
Environmental condi-
tions in operation
+5 °C to +45 °C;
20% to 75% humidity
Problem
Cause
Solution
Nothing
appears in
the display.
The handset is not
switched on.
Battery pack is
flat.
Press the End call key
a
for
approx. 5 sec-
onds
or place the
handset into the
charging cradle.
Charge/replace the
battery pack (page 2).
No reaction to
keystroke.
The key lock is
activated.
Press the hash key
R
for
approx. 2 sec-
onds
No wireless
connection to
the base sta-
tion,
Base
flashes in the
display.
The handset is
outside the range
of the base sta-
tion.
The handset is not
registered.
The base station is
not switched on.
Move the handset
closer to the base
station.
Register the handset
Check the mains plug
on the base station.
!
