Gigaset E290HX, User Manual

Page: 43 / 56

Gigaset E290HX / LHSG IE-UK-International en / A31008-M2961-R101-1-4N19 / settings.fm / 5/30/19
Tem
p
la
te Mo
dule
, El
de
rl
y,
V
er
sio
n 1.
1,
01
.0
4.
20
19
Phone settings
Availability and operation of the functions
may differ on your telephone.
43
Resetting the base using a key on the base
All handsets are de-registered. The system PIN is set back to the original code
0000 .
¤
Unplug the power cable from the base Keep pressed the Register/
Paging key on the base At the same time, reconnect the power cable to
the base Keep the key pressed for at least another 5 seconds
Firmware update
(depending on the base)
The handset supports firmware updating via the DECT radio link to the base/
router (SUOTA = Software Update Over The Air).
¤
Settings OK Handset OK Update Firmware . . . the
current firmware version is displayed Update OK . . . if there is new
firmware, updating is started
Automatically check whether there is new firmware:
¤
Settings OK Handset OK Update Firmware
Automatic Check OK ( = enabled)
If new firmware is available for the handset, a message to this effect is
displayed.
¤
Start the firmware update with OK .
Connections
(only on a CAT-iq router)
On the router, multiple connections can be set up and assigned to the hand-
sets. You can configure the following connection settings on the handset.
Change the name of a connection (line)
¤
Settings OK Base OK Connections OK . . . All
available connections (lines) are displayed Select connection
OK Connection Name Change name of connection OK
The base/router to which the handset is registered must also support
this function and be connected to the Internet
www.gigaset.com/compatibility
The update process may take up to 30 minutes. During this time,
only restricted handset use is available.