A39H/A49H / Andina - en / A31008-M2250-U501-2-3P19 / starting.fm / 23.03.2011
6
Registering the handset to the base station
Before you can use the phone, you must first register the handset to the base sta-
tion. The actual registration procedure will depend on the type of base station.
You must activate manual registration of the handset
on both the handset and
the base station
.
1. On the base station:
press and hold the registration/paging key for min. 3 sec.
2. On the handset:
within
60 sec.
of pressing the registration/paging key
MENU
¢
Settings
¢
OK
¢
Handset
¢
OK
¢
Register HS
¢
OK
¢
Enter the system PIN of the base station (default is 0000)
¢
OK
.
Registering
flashes in the display.
Registration takes approx. 1 minute.
The following is displayed after succesful
registration:
If more than one handset is registered, the internal
number of the handset is shown in the upper left cor-
ner.
Initial charging and discharging of the
batteries
The correct charge level can only be displayed if the batteries are first fully charged
and
discharged.
Please note
◆
After the first battery charge
and
discharge you may replace your handset
in the base station or charging cradle after every call.
◆
Always repeat the charging and discharging procedure if you remove the
batteries from the handset and reinsert them.
◆
The batteries may warm up during charging. This is not dangerous.
Warning
Please ensure that the handset is in the charging cradle if you are absent for a
long time (e.g. during holidays) or remove the batteries from the handset. Oth-
erwise the batteries could be damaged.
U
INT
MENU
¤
Place the handset in the base station or charging cradle for
18
hours.
¤
Then remove the handset from the base station or charging cra-
dle and do not replace it until the batteries are completely dis-
charged.
18 h
