Gigamon GigaVUE-HC3, Hardware Installation Manual

Page: 81 / 142

Basic GigaVUE H Series Connections and Configuration 81
4.
Insert the fan modules into the fan tray one at a time as shown in Figure 4-14 on
page 81 .
Figure 4-14: Fan Module Insertion
5.
Tighten the thumb screws on each fan module, then use a Phillips screwdriver to
tighten the screws. Refer to
Figure 4-7 on page 77 .
6.
Tighten the thumb screws on the fan tray, then use a Phillips screwdriver to tighten
the screws. Refer to
Figure 4-10 on page 79 .
Removing the Extension Board
The GigaVUE-HC3 extension board is located in the front of the chassis. It is field
replaceable, however, the node must be powered down. Hot swapping is not possible.
To remove the extension board:
1.
Power down the node.