You specify the timezone in terms of the offset from UTC (either plus or minus). For
example, to set the timezone for a GigaVUE TA Series node in the United States for
Pacific Standard Timezone, you would use the following command:
(config) # clock timezone America North United_States Pacific
Once you’ve finished configuring NTP options, use the
show ntp
command to
check the status of clock synchronization (
Figure 7Checking NTP Status and
).
Figure 7
Checking NTP Status and Configuration
Configuring Automatic Email Notifications
The GigaVUE TA Series nodes provide powerful email notification capabilities,
automatically sending emails to specified addresses when any of a wide variety of events
take place on the system. Gigamon strongly recommends that you configure this feature
so you have immediate visibility of events affecting system health.
You configure automatic email notifications with the
command and its arguments.
Start by making sure the CLI is in Configure mode. If the
(config)
entry appears in the
system prompt, you are in Configure mode. If not, use the
enable
and
configure
terminal
commands sequentially to change to Configure mode. Then, configure email
notifications as follows:
Description
Command
First, use the
mailhub
command to
specify the mail server to
use for notification emails.
In this example, the email
server named
smtp.emailsrvr.com
is
used. IP address can be
used instead of a
hostname.
(config) # email mailhub smtp.emailsrvr.com
Next, use the
email auth
command to supply the
email account username
and password. In this
example,
(config) # email auth username
[email protected]
(config) # email auth password mypassword123
Contents
38
GigaVUE-TA25E Hardware Installation Guide
